Knowledge of safe operation of forklift

In order to effectively prevent, timely control and elimination of sudden special equipment accident hazards, the maximum is to reduce special equipment accidents. To ensure that the forklift driver safe, accurate, standardized and effective operation of the semi electric order picker.
First, forklift common violations
Second, the safe operation of forklift procedures
Third, the forklift operation "eight are not allowed"
Driving forklifts must be trained and held with special equipment operating personnel permit to drive the Electric fork over stacker

Do not operate the hydraulic system before the hydraulic system oil gets hot.

therwise, it will damage the hydraulic components. electric rider pallet truck in the driving to control the speed, keep the car away from, to avoid emergency braking, cold season braking interval than usual to extend about 2 times. It is forbidden to steer and reduce the impact force during cornering to prevent breakage of the rigid structural parts.
To do the equipment season maintenance work, the detection of antifreeze freezing point, making it lower than the local minimum temperature 5 ℃; so that the temperature of the thermostat open at about 82 ℃; the battery electrolyte density raised to 1.280g / cm3; timely adjustment of the machine The Ministry of oil, the work of the field equipment to install insulation measures, if necessary, install the engine oil preheating device, and start the engine regularly, preheat the various parts of the working system.
Normal start-up of the engine should have sufficient warm-up time to operate at low speed light load until the oil in the engine, transmission, hydraulic system and final drive heats up. Equipment at work, the operation of the bucket, blade and a variety of devices to be slow, to prohibit the impact of large throttle, scraping, shovel and push, the focus on "stable" and "slow". Winter is the season of high accidents, accounting for about 80% of the total annual accidents, and winter accidents due to operational accidents caused by more than 65%. If the temperature below -15 ℃, the engine can not start immediately after the start of the work, but should make the engine to 1000-1100r / min running 10-15min, and the transmission in neutral. So to regularly check the forklift machine rigid connection and the main load-bearing parts.

What is the main force in the future forklift market?

Forklift nearly two years of sales, the growth rate of more than 15%, Hangzhou crane truck forklift rental also introduced new forklift. In the sales, the internal combustion engine occupies an absolute proportion, but the internal combustion engine is not the main force of the future forklift industry, but the battery forklift.
With the domestic forklift industry market, a substantial increase in the industry's demand for weight in the past two years also continued to grow, the main driving force is still internal combustion Electric Fork Over Stackers. Internal combustion forklift dynamic performance, speed, fork lift speed, traction and other indicators are higher than the battery forklift. And for Hangzhou forklift rental and other host companies, the cost of control is to continue to use one of the main reasons for internal combustion forklift. The domestic product structure is still stuck in the internal combustion Electric counterbalance stacker for the mainstream product stage, so the internal combustion forklift industry want to do a large-scale adjustment is not a matter of time.
Today, in the context of low-carbon environmental protection, the forklift industry's power source to the power-driven upgrade is a must. Chinese companies must take the strategy of overseas markets, the use of battery forklift, will be positioned in the service exports, appropriate to cultivate the domestic market share. Can be expected, the future forklift market, the main force must be a battery forklift. But from the market point of view, only the fuel cost pressures and emissions regulations of the double constraints of a profound impact on the forklift business, will promote the real change of the advent of. Prior to this, the internal combustion forklift will continue to occupy the mainstream market position.

Industrial transport vehicles are widely used in ports, stations, airports, freight yard, factory workshops, warehouses, distribution centers and distribution centers, etc., and can enter the cabin, cars and containers for pallet cargo handling, handling operations, tray transport, container transport Indispensable equipment.
Forklift in the enterprise's logistics system plays a very important role, is the main force in the material handling equipment. Widely used in stations, ports, airports, factories, warehouses and other departments in the national economy, is mechanized loading and unloading, stacking and short-distance transport of efficient equipment. electric walkie pallet jack appeared in 1917. During the Second World War, the forklift was developed. China began manufacturing forklifts from the early 1950s. Especially with the rapid development of China's economy, most of the enterprise material handling has been divorced from the original manual handling, replaced by forklift-based mechanized handling. Therefore, in the past few years, China's forklift market demand every year to double-digit growth rate.

electric rider pallet truck because of its operational control is simple and flexible, the operator's operating intensity is much lighter than the internal combustion forklift, the electric steering system, acceleration control system, hydraulic control system and brake system are controlled by the electrical signal, greatly reduced The labor intensity of the operator, so as to improve the efficiency of their work and the accuracy of the work is very helpful. And compared to internal combustion forklifts, electric vehicles, low noise, no exhaust emissions advantages have also been recognized by many users.
In addition, the choice of High Lifting stacker there are some technical reasons. The rapid development of electronic control technology makes electric forklift operation more and more comfortable, the wider the scope of application, to solve the logistics program more and more. These aspects, the electric forklift market demand will certainly grow faster and faster, electric forklift market share will be more and more.

All-electric van, all-electric stacker common faults and troubleshooting methods

All electric van, all-Electric and Manual Straddle Stacker in the use of the process will encounter some of the more common failure, so the failure does not require professional forklift maintenance personnel to deal with, only need to repair maintenance personnel to deal with the fault on it, we look at See, all-electric van, all-Electric Straddle Stackers common fault which? How to deal with
All-electric truck common fault and troubleshooting methods:
All the electric van in the course of the use of hydraulic oil leakage failure, the approach is very simple, this is due to the seal wear or fracture caused by this time only need a better seal on the cylinder can, and a May be inside the cylinder parts of the wear and tear of the general cracks, this time only need to replace the inside of the cylinder can be spare parts, such as seals will lead to air into the hydraulic system, this time only need to rise and fall many times, that can be discharged hydraulic The air inside the tank; all electric van did not put pressure but the truck down, this may be impurities in the hydraulic oil, resulting in the valve can not be closed, this time only need to replace the clean hydraulic oil can, and there may be Put pressure valve is not adjusted, this time need to adjust the pressure valve on it.

Forklift battery safe use ten points

semi electric order picker traction battery, also known as High Lifting stacker, as the forklift driver, must comply with the correct code of practice, safe use, keep in mind the following basic ten points Note:
    1. The battery will produce hydrogen, may cause an explosion, is strictly prohibited in the vicinity of the battery smoking, is strictly prohibited any flames or sparks. The battery must be in a well ventilated place during storage or charging, but not at the outlet, to avoid corrosion caused by acid mist.
    2. The battery liquid contains corrosive liquids, may cause severe burns, to avoid contact with skin, eyes or clothes, if unfortunate accident, please immediately rinse with plenty of water, and quick medical treatment.
    3. When checking or servicing the battery, use rubber gloves to avoid electric shock.
    4. The battery surface or connection must be kept clean. Dust, impurities, etc. must be cleaned with a damp cloth, otherwise it will leak, and even cause a fire.
    5. When cleaning the battery, be sure to use a damp cloth, do not use dry cloth.
    6. Do not connect the positive and negative electrodes of the battery with tools.
    7. Charge the electrolyte temperature should not exceed 50 degrees Celsius, so as to avoid electrolyte damage caused by overflow, especially during the summer to pay attention.
    8. Before pulling the battery plug, to avoid sparks, be sure to turn off the forklift key switch and charger switch.
    9. Electrolyte surface should not be below the minimum, otherwise the battery is hot, easy to burn.
    10. children do not near.