Common Problems and Maintenance Methods of Semi - electric Stacker

Doubt one: balance heavy heap car mast tilt, mast imbalance, how do?
In this case, we must first analyze its elements. The most important thing is the valve valve stem valve failure; tilt the cylinder wall and the ring over-wear; tilt too much fouling or seal too tight and so on. Then we can be able to analyze each and every one because of the past. For example, the replacement of new springs and seals, seals too tight can also be adjusted.
Doubt two: balance heavy Electric Riding Pallet Jack car drive wheel speed reduction situation, how to do?
The high speed of the drive wheel of the Electric counterbalance stacker may drive the motor seriously overloaded mainly because the battery voltage is too low or the pile head is too touchable, the cleaning pile head can reduce the resistance and the battery voltage is low to replace the new battery.
Question 3: stacking car circuit is not working properly, how do?
There may be two elements of this situation, respectively, electrical box within the micro-switch damage may be improperly adjusted or the main circuit fuse may control the electrical fuse fuse. If it is the former, then only need to replace the micro switch, adjust the orientation from scratch; if the latter elements caused by the need to replace the same type of fuse.

Performance characteristics of electric pallet truck

self propelled pallet truck drive wheel, load wheel, balance wheel selection of special technology rubber / polyurethane wheel, greatly extended the use of grant; ultra-small body plan, can be applied to a variety of small channels; operating speed, carrying capacity, great Progressive power; imported stepless speed control computer system, large capacity traction battery Multi-function handle: the operator can launch the vehicle through the electronic lock. Easy to control the speed of the trek, to speed up just turn the handle on the accelerator switch, the greater the rotation, the faster the speed.
Delay acceleration work: the operator such as the speed of trekking has always been rotated to the fastest speed, the machine unique work will be active to open, there will be 3-8 seconds from low speed high-speed operation to prevent the formation of too fast to damage.
Power brake brake work: the handle is erected when the brake, the operation of walking down the handle after the point of operation, according to the time when the brakes, when the downhill when the goods immediately, the operator can also stop on the slope, Prevent the car from sliding downhill and reducing the trouble.
Five fulcrum structures: a common structure can bring a higher stability of the vehicle, especially on the slippery ground or slope, better reflect its role.
Driving wheel damping system: the pressure of the drive wheel with the load and light weight changes, the machine damping system will be based on their own goods to light their own shock, especially on the ground is not flat, even more unique role. On the vehicle walking, stable function of their own scheduling.
Battery, power indicator: lunch when the battery power to control how much power shortage of active alarm workers.

Electric pallet truck and electric storage forklift usually protect what

1, see the leakage situation, the focus is: the pipe joints, brake pumps, lifting cylinders, water tanks, engines, transmissions, drive axle, pressure steering, steering cylinders and so on.
2, tire pressure view: lack of compensation should be made to the specified value, admit that no leakage. Check the tire on the ground and the side of the surface without damage, the rim is not deformed.
3, the view of the polyurethane tires: view the road conditions with the same, look at the tire is not a greater degree of wear and tear, the device has a markings of the tires, the wheel should pay attention to the direction of rolling symbols.
4, brake fluid, water View: View brake fluid is not in the range of scale, and see the brake pipe is not mixed into the air. Increase the brake fluid, to avoid dust, water mixed into. When adding water to the tank, use clean water, if the use of antifreeze, should return the same antifreeze. When the water temperature is higher than 70 degrees, open the tank cover, open the lid, the pad a thin cloth, do not wear sets of water tank cover.
5, electric storage semi electric stacker hydraulic oil, electrolytic view: first set out the oil scale, wipe the foot after the first insert and then pull out to see if the oil level is not between the two lines. The oil level in the working tank should be between two tick marks; the oil is too small and the air will be mixed in the pipe, and too much will overflow from the cover. Battery electrolyte is also the same to be between the upper and lower tick marks, the lack of distilled water will be added to the top line.
6, brake springboard, micro pedal, hand brake View: depress the pedal to see if there is abnormal dull or stuck. Recognize the safety and reliability of the electric forklift handle.
7, belts, speakers, lights, appearance, etc. View: View the electric forklift belt tightness is not in line with the provisions of the adjustment of the margin or damage without cracks, to be replaced; speakers, lights, the appearance should be normal and useful.
8, battery protection: electric forklift should pay special attention to the timely charging of the battery and battery and protection, battery charging should pay attention to the way, it is necessary to make the battery enough electricity, and can not form a battery overcharge. Found that the lack of electricity, you should quickly charge to avoid excessive battery discharge.
9, the vehicle is running, do not "forward, backward" direction switch mistaken as a steering switch.
10, put the oil filter sediment.
11, check the consolidation of the various parts of the situation, the focus is: fork support, lifting chain tension screw, wheel screws, wheel fixed pin, brake diverter screw.
12, view the steering of the reliability, flexibility.
13, clean electric forklift dirt, dirt and scale, the key parts are: fork and gantry slide, generators and starters, battery electrode fork tank, air filter.